Vehicle Recalls

The missing weld could result in trailer separation, increasing the risk of a crash.

If the seat does not fully lock into the inboard seat track, the seat could move, increasing the risk of injury to an occupant in the event of a crash.

If the carrier cable is corroded due to road salt, the spare tire may separate from the vehicle, increasing the risk of a crash.

In the event of a crash, a larger front passenger seat occupant may not be properly restrained and be at an increased risk of injury.

A short in the circuit board increases the risk of a fire.

If the switch fails, the vehicle may begin braking without the driver's input, and without illuminating the brake lights, increasing the risk of a crash.

If the cable does not clear the wheel chair lift it may contact the power lug and if it does not have a nonconductive cover, or it has an improperly installed non-conductive cover, then a short circuit may occur that could result in a fire.

Failure of the pivot bolts may cause the suspension and attached axle to separate from the trailer, increasing the risk of a crash.

Due to the exhaust's proximity and the lack of heat shielding, the hot exhaust piping could heat the propane tank and cause it to expand and vent off any build up of pressure, increasing the risk of a fire. The exhaust exiting below a slide out room may cause carbon monoxide to enter the vehicle, increasing the risk of asphyxiation.

If the steel cable becomes fatigued and separates, the seatbelt may not properly restrain the seat occupant increasing the risk of an injury in a crash.

This could result in an arcing condition, and combustible materials located nearby could ignite and result in an engine compartment fire.

An engine stall may increase the risk of a crash.

An unexpected vehicle shut down increases the risk of a crash.

If the heat generated within the headlamp switch or DRL module located on the left side of the steering column melts the headlamp switch or DRL module, there is an increased risk of a fire.

If the DRL module melts due to the heat generation, it could cause a vehicle fire.

In the event of an accident, an air bag that only partially deploys increases the risk of occupant injury.

If the driveshaft fractures and separates while driving, the vehicle would lose power and coast to a stop. If a vehicle with a fractured driveshaft is parked without the parking brake applied, the vehicle could move unexpectedly. Either condition increases the risk of a crash.

If the cable does not clear the wheel chair lift it may contact the power lug and if it does not have a nonconductive cover, or it has an improperly installed non-conductive cover, then a short circuit may occur that could result in a fire.

If the cable does not clear the wheel chair lift it may contact the power lug and if it does not have a nonconductive cover, or it has an improperly installed non-conductive cover, then a short circuit may occur that could result in a fire.

The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.